Skip to next element
Steps 1
- Set your hex tool to 4mm
- Then disconnect the rear motor cable
Steps 2
- Carefully loosen bolts, do not fully remove just yet.
- Remove spring clip (blue arrow) and set aside.
- After removing the spring clip, remove the bolts.
Steps 3
- Align kickstand with brake caliper and begin to screw in the bolts.
Steps 4
- When tightening the kickstand and brake caliper together, ensure the brake disc is centered between the brake pads (see image)
Steps 5
- Return the spring clip to its original position.
- Reattach the rear motor cable on the outside of the kickstand.
- To do so, make sure arrows are aligned
- Choosing a selection results in a full page refresh.
